RCU Forums - Search Results

Search: Posts Made By: Fytch

Showing results 1 to 6 of 6
Search took 0.05 seconds.

Forum: "1/2 A" & "1/8 A" airplanes

08-19-2010, 01:04 PM

Replies: 538

Sticky Norvel Engine FAQ

Views: 192,583

Posted By Fytch

RE: Norvel Engine FAQ

i think it could be a cylinder to piston seal, am building a plane now to run the engine on.

probably there is not much castor in there to make a good seal.

thanks Dave.

Forum: "1/2 A" & "1/8 A" airplanes

08-04-2010, 12:00 PM

Replies: 538

Sticky Norvel Engine FAQ

Views: 192,583

Posted By Fytch

RE: Norvel Engine FAQ

guys, my norvel is leaking, i can hear it when i push over the prop slowly.

i opened it out and saw 1 gasket between the case and the cylinder, and a copper shim in between the head and the...

Forum: "1/2 A" & "1/8 A" airplanes

07-25-2010, 08:59 PM

Replies: 538

Sticky Norvel Engine FAQ

Views: 192,583

Posted By Fytch

RE: Norvel Engine FAQ

tru,

you could try taking the piston out and try to fit it into a 049 cyclinder and see if it fits. i always do that when i am unsure, not sure if it is the correct way.

which part of Malaysia...

Forum: "1/2 A" & "1/8 A" airplanes

07-24-2010, 12:08 PM

Replies: 538

Sticky Norvel Engine FAQ

Views: 192,583

Posted By Fytch

RE: Norvel Engine FAQ

found the timing wheels, i have to agree with you Toad, this mod does not work.

may i ask, those bronze bushings u installed into your homemade engine, it is an interference fit to the caseright?...

Forum: "1/2 A" & "1/8 A" airplanes

07-23-2010, 08:33 PM

Replies: 538

Sticky Norvel Engine FAQ

Views: 192,583

Posted By Fytch

RE: Norvel Engine FAQ

Toad, is there any webpage you could give me some light on Timming wheels? i tried to search on the net but couldnt find any.

anyway i have an 061 with a rear bearing installed, this was done by...

Forum: "1/2 A" & "1/8 A" airplanes

07-22-2010, 11:50 AM

Replies: 538

Sticky Norvel Engine FAQ

Views: 192,583

Posted By Fytch

RE: Norvel Engine FAQ

guys, i just had an idea.

anyone tried putting cox tee dee crankshafts into norvel crankcases??

i know the TD crankshaft is 7mm and the norvel ones are 7.5. but what if i have 2 bearings in...

Showing results 1 to 6 of 6