RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: rfbenn
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Forum: RC Jets
03-01-2021, 09:33 AM
Replies: 1,019
Views: 275,509
Posted By rfbenn

I don’t have another to check it against,...

I don’t have another to check it against, although I had one a while ago and that worked fine so I’m familiar with its operation, I guess this one’s faulty as I got the same result with two different...
Forum: RC Jets
03-01-2021, 02:54 AM
Replies: 1,019
Views: 275,509
Posted By rfbenn

I tried with a Futaba 7008 with the same result...

I tried with a Futaba 7008 with the same result using sbus/serial mode all surfaces were out 5 degrees or so using the loom everything was fine.
Is it worth sending to Bavarian or just use it in...
Forum: RC Jets
02-28-2021, 01:40 PM
Replies: 1,019
Views: 275,509
Posted By rfbenn

Ok so I went through the process again, I...

Ok so I went through the process again, I disconnected the gyro and put the leads back into receiver and confirmed that the surfaces were where I expected them to be .
The receiver is a Futaba 7014...
Forum: RC Jets
02-27-2021, 02:45 PM
Replies: 1,019
Views: 275,509
Posted By rfbenn

I’ll check it out & try again. Thanks

I’ll check it out & try again.
Thanks
Forum: RC Jets
02-27-2021, 08:10 AM
Replies: 1,019
Views: 275,509
Posted By rfbenn

The problem showed up on the initial set up in...

The problem showed up on the initial set up in the workshop using Sbus, as soon as I set it up with the loom ( which doesn’t use sbus) all the surface trims were fine.
I have tried to contact...
Forum: RC Jets
02-22-2021, 07:33 AM
Replies: 1,019
Views: 275,509
Posted By rfbenn

Cortex Pro problem

Hi
I recently bought a Cortex Pro from someone I know, one of the limited edition red versions and put it in my T One Fortune which has been flown many times and is all trimmed out , using the...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.